The reason for writing this article was the article “ I wanted to buy an inexpensive 3D printer, but I watched YouTube and didn't want to, ” at the end of which the author asks you to answer a few questions. I'll try to answer from the point of view of my seven years of experience as a 3D modeler and 3D printer. First, a few caveats.
In this article, there will be no advice: “Buy a printer from manufacturer X - it is good, and manufacturer Y - do not take it in any case”, only general recommendations.
The classification of printers is informal, adopted in the domestic segment of printers.
.
- .
: 2013 . Makerbot 2 "Migce Cuble".
3D- , “” , - 3D , , . , “ ” “ , ”. 7 . , , “3D Today”, , . : “ ”. , . - : “ ?”.
: FDM (FFF) - , SLA (LCD) - . FDM , - , LCD FDM .
, SLA- LCD- ( ), FDM . 3 :
- , . . , , . , , TPU.
- . , . . , ABS Nylon. . , .
- , , -, , , . . . , , “” - .
, .
3 :
( ) - , .
, , . , . , “ ”, - .
/ / . , . , .
( ) - “ZAV”, “UlTi”, “” .. . . - , .
, . , . , / .
, . .
( / ). , .
“ ”. .
- . . , - . - , : , , , . , , .
, , . 3D- - , . :
- - , - . , - .
, . , - . - - . - , .
- , . , / - . - , , SLA/LCD- .
. - LCD-, - .
, , , - , . -. .
, - LCD-.
, - . - .
, , - . . . , , , , . , , , . , , , 80-90 .
, , , . .
, - . . - .
- ?
- - . , - “ 3 ()” . .
- - “” . 3D- .
- . () ABS, .
- .
- CoreXY, H-Bot Delta 32- , () .
, , . - . - - .
, 3D- - - 3D-. , - https://www.tinkercad.com. .
- . - () (Blender ..) - , , .
On this I will probably round off - the article is already quite voluminous, if you have any questions, I will be happy to answer them in the comments or in a separate article. I say right away that I will not answer questions such as “ which is better: flying bear 5 or ender 3 ” - many copies on this topic have already been broken on specialized resources, I see no reason to repeat myself.
Best regards, Maxim.